BMW M2 High Performance Software Tuning

by: Active Autowerke




After over a year of testing with our M2, we're now releasing our performance software flash!

Our M2 has seen dozens of track days and after extensive R&D we've settled on a final tune that we believe will produce the most consistent and reliable power lap after lap without falling off or causing any drivetrain malfunctions. Being in Miami, we see some of the hottest and most humid temps in the country!

Approaching the 400whp mark has caused fueling issues with the stock fuel system and adding any more torque down low will cause power levels to drop up top when temps rise. We've been able to extract ~415 lb/ft of torque and ~378whp lap after lap without any problems. When we bumped up the torque to ~430 lb/ft the car would make inconsistent power at higher RPMs due to varied ignition timing and throttle opening. Increasing the power to 400whp led to drivetrain malfunctions caused by lowered fuel pressure.

Our ECU reflash corrects the leaner stock AFR ratio allowing us to increase boost safely and reliably. We lower the AFR sooner and more significantly compared to the stock curve to promote consistent power lap after lap. Piggyback units do not modify the AFR and thus have not proven to provide consistent performance during extended use.

Key Features:

Horsepower and torque gains throughout the entire RPM band
Recalibrated settings for a smoother and more responsive part throttle transition
Recalibrated settings for a smoother and more responsive power delivery
Modified Vanos camshaft remapping
Available "Burble" Maps
Free tech support and assistance
Multiple maps available for flashing at home (after initial reflash)

Available Options:

Cold start delete
Off Road Only Downpipe Map
Burble Option
Tuner flag removal
OBD Flashing Option

     

    Performance Specs:
    Up to 50hp gains   :   Rear wheel HP measured on the dyno
    Up to 80 Ft / LBs gains  :   Rear wheel FT/LBs measured on the dyno

     

    Software Purchase Options:
    When you purchase software for your BMW M2, you will be required to: 

    1) Locate an Active Autowerke approved M2 Software Dealer and have it installed there

    or

    2) Remove and mail Active Autowerke your ECU and we will install the software. Same day
    turnaround on all software with free 2nd day air to lower 48 states. See Tech Support for
    details on removal and mailing of ECU.
    Click here for Instructions on Removing ECU

    After the initial reflash, you are able to flash different maps from us with a Simon 3 cable that available for an additional $225. If you choose not to purchase a Simon 3 cable we will flash your ECU with a custom map at your request. 

    We provide up to (4) custom maps (at no additional cost) when you purchase a Simon 3 cable with your F1X Peformance Software!

    ***Your ECU must be taken to an approved Active Autowerke F3X dealer for the initial flash, or it must be shipped to Active Autowerke before you are able to load our maps with a Simon 3 cable from your home. 

      

     

     

     

     



    Related Items